They are specifically designed to pass the necessary frequencies. These arrestors do not interfere with the incoming signal - no matter what Comcast says. Here are some reasons why: The camera (s) are too far away from the home router. Video loss or weak video signal on security cameras on a wireless network segment could be caused by unstable network connections, a weak WiFi connection or low internet bandwidth. The conductivity of the ground can be measured and repaired if necessary. Reason 3: Weak WiFi Connection or Low Bandwidth. Even if you have a modern system with proper ground rods and the proper depth, the capacity of the system degrades over time due to corrosion. (2) Grounding - You need and expert to design, install and troubleshoot. Basically, the rod must project well above any other part of the structure and the path to ground must be straight. (1) Lightning rod - You need an expert to design and install properly. That said, there are thee things you can do to minimize damage: (1) properly install a lighting rod (2) ground the building electrical system properly and (3) put lightning arrestors on all incoming connections. The second time, the equipment protected by lightning arrestors survived. The first time everything was taken out - even LED bulbs. I had DirecTV for 18 years and never lost any equipment.Īnyone else had similar experiences? This is going to definitely figure into my decision as to whether to keep comcast or go back to DTV when my contract ends this spring.Lightning is unpredictable and the RF energy and side flashes can take out anything electronic - even if unplugged. The second occurrence was yesterday, with a corresponding TV/Internet outage in the area, which killed a third TV and its X1 box. The first occurrence left 2 boxes dead and one of the TVs completely dead, the other with dead HDMI ports (all three of them).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |